Sony PMW-PZ1, Service Manual

Page: 30 / 78

2. Find out the volume number of Windows area.
Make sure that “Volume 0” is shown in the Volume ### column for the volume of which Label column is shown
as “Windows” and Size column “40 GB”.
3. Find out the volume number of Work area.
Make sure that “Volume 1” is shown in the Volume ### column for the volume of which Label column is shown
as “Work” and Size column “2048 MB”.
4. Find out the volume number of Recovery area.
Make sure that “Volume 3” is shown in the Volume ### column for the volume of which label column is shown
as “Recovery”.
Note
The assigned letters of the volumes differ depending on the environment.
Tip
Volume 6 as E drive: USB memory in which Windows PE is stored
Volume 5 as F drive: SxS slot
Volume 0 through 4: Partitions on the SSD
5. Execute the following commands for the area of Volume 1 (2048 MB, Label: Work) found out in step three to
initialize the volume.
DISKPART> select volume 1
DISKPART> format quick fs=ntfs label=“Work”
The Work area is formatted.
6. Execute the following commands for the area of Volume 3 (10 GB, Label: Recovery) found out in step four.
DISKPART> select volume 3
DISKPART> assign letter=R
Drive letter of “R” is added to the Recovery area.
7. Execute the following command.
DISKPART> list volume
Volume list is displayed.
Example
Volume ### Ltr Label Fs Type Size Status Info
---------- --- ----------- ----- ---------- ------- --------- --------
Volume 0 C Windows NTFS Partition 45 GB Healthy
Volume 1 D Work NTFS Partition 2048 MB Healthy
Volume 2 Windows RE NTFS Partition 600 MB Healthy Hidden
* Volume 3 R Recovery NTFS Partition 10 GB Healthy Hidden
Volume 4 SYSTEM FAT32 Partition 100 MB Healthy Hidden
Volume 5 F Removable 0 B No Media
Volume 6 E WinPE FAT32 Removable XXXX MB Healthy
8. Make sure that “R” is shown in the Ltr column for Volume 3.
9. Execute the following command.
DISKPART> exit
“Leaving Diskpart...” is displayed, and then DISKPART command is closed.
Recovering OS
1. Start the command prompt.
PMW-PZ1
1-22