134
Setting for a Multipoint Connection
5
Select “Save”, then press the PUSH ENTER button.
The registration of the multipoint connection list is completed.
You can set “Total Bandwidth” (Communication Bit Rate of total points) in the
Communication Mode Menu in this unit.
The actual Communication Bit Rate may not be the value set in the List Edit menu
because the Communication Bit Rate on each point is automatically adjusted so that
the total bit rate of all points does not exceed “Total Bandwidth” in Multipoint
connection.
To specify a remote party registered in the Phone Book to the multipoint
connection list
1
Use the
V
,
v
,
B
or
b
button on the Remote Commander to select the name
you want to register in the multipoint connection list.
2
Press the
button on the Remote Commander, or press the PUSH
ENTER button to open the submenu, press the
V
or
v
button to select “
On”, then press the PUSH ENTER button.
The
(multipoint) mark is added to the lower right of the selected name in
the list and the remote party is registered in the multipoint connection list.
You can add the
marks for up to three parties using the same procedure as
above. The
marks are displayed at the upper right corner of the Phone
Book, showing how many points you registered for a multipoint connection.
Note
Phone Book
Cancel
2005.12.28 12:34
0-9
A-I
J-S
T-Z
New Entry
Recent
Room 10A
Room 16A
Room 11B
Room 16B
Room 12A
Room 17A
Room 12B
Room 18A
D i a l
O n
Edit
C o py
Delete
Cancel
