![background image](http://html.mh-extra.com/html/sony/hcd-md555/hcd-md555_service-manual_420816039.webp)
— 39 —
OPERATING THE CONTINUOUS PLAYBACK MODE
1. How to Enter the Continuous Playback Mode
1
Insert a disc in slot 1. (Either a recordable disc or playback-only disc can be used.) Press the MD
§
button to load the disc.
2
Turn the MULTI JIG dial until “CPLAY MODE” (30) appears on the display.
3
Press the ENTER/YES button and the display changes to “CPLAY MID”.
4
When the disc is accessed, the display changes to “C=
AD=
”.
Note:
The number in the “ ” area on the display indicates the error rate and “ADER”.
2. How to Change the Playback Segment
1
If you press the ENTER/YES button during continuous playback, the display changes as shown below and a different segment can
be played back.
“CPLAY MID”
n
“CPLAY OUT”
n
“CPLAY IN”
2
When access to the segment is completed, the display changes to “C=
AD=
”.
Note:
The number in the “ ” area on the display indicates the error rate and “ADER”.
3. Ending the Continuous Playback Mode
1
Press the EDIT/NO button. The display changes to “CPLAY MODE”.
2
To remove the disc, press the MD
§
button.
Note:
The playback start addresses for IN, MID, and OUT are as follows.
IN
: 40h cluster
MID : 300h cluster
OUT : 700h cluster
n
Summary of Contents for HCD-MD555
