Sony Esprit TAV-L1, Operating Instructions Manual

Page: 26 / 383

26
GB
Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 15)
Press PROG +/–, or the number buttons, to select the
video channel. You can also press
/ repeatedly
until the correct input symbol (see below) appears on
the screen.
For other connected equipment
Press / repeatedly until the correct input
symbol (see below) appears on the screen or press OK
to access the Input signal index table. Press
, to
select an input source, press m / M , then press OK.
Additional operations
* Note that this button may not be available in some countries.
Add or remove
channels in the
Favourite list
1
Press the blue button.
Channels that are stored in
the Favourite list are
indicated by a
symbol.
2
Press
M
/
m
to select the
channel you want to add
or remove.
If there are more than five
channels in the list, press the
green button for the next five
channels or press the red
button for the previous five
channels. If you know the
channel number, you can use
the number buttons to
directly select a channel.
3
Press (OK).
4
Press the blue button to
return to the Favourite
list.
Remove all channels
from the Favourite
list
1
Press the blue button.
2
Press the yellow button.
A display appears to confirm
that you want to delete all
channels from the Favourite
list.
3
Press
<
to select [Yes],
then press (OK) to
confirm.
To Do this
1/ 1, 2/ 2:
Audio/video or RGB input signal through the scart
socket
/ 1 or 2. appears only if an RGB
source has been connected.
4/ 4:
Video input signal through the video socket 4, and
audio input signal through the audio socket L/G/S/I
(MONO), R/D/D/D sockets
4. appears only if
the equipment is connected to the S video socket 4
instead of the video socket 4, and S video input
signal is input through the S video socket 4.
5:
RGB input signal through the PC connectors 5, and
audio input signal through the socket .
6:
Digital audio/video signal is input through the HDMI IN
6 socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
To Do this
Return to the normal
TV operation Press DIGITAL* or ANALOG.
Access the Input
signal index table Press (OK), then press
,
. To
select an input source, press
M
/
m
,
then press (OK).