Sony DNW-A28, Operation Manual

Page: 67 / 102

Chapter 6 Setup Menu
Chapter 6 Setup Menu
6-5
2
When the desired setting value is displayed, press
the SET button.
This saves the new setting value, and the menu
display disappears.
To abandon making a change
Press the MENU button before pressing the SET
button.
The menu display disappears from the monitor and FL
display panel, without the new setting value being
saved.
Resetting the menu settings to their
factory default values (menu item B20)
1
Set menu item B20 RESET SETUP to ON.
“PUSH SET BTN” appears in the FL display
panel, and “Push SET button” appears on the
monitor.
2
Press the SET button.
The current active menu settings are reset to their
factory default settings.
3
Press the SET button again.
The settings are saved and the menu display
disappears.
Switching between 525/625 line systems
(menu item 013)
Using the following procedure, you can set basic menu
item 013, 525/625 SYSTEM SELECT, to “ON”, and
then switch between 525 (NTSC) and 625 (PAL).
(The following procedure shows by way of example
how to switch from a 525 (NTSC) system to a 625
(PAL) system.)
Note
After switching, playback of Betacam/Betacam SP
cassettes is also performed in the selected mode.
However in 625 mode, only simple viewing is allowed
and the capstan lock mode is fixed to 2FD.
1
Select menu item 013.
The monitor shows the following display.
525/625 SYSTEM
SELECT
ITEM-013
OFF
2
Turn the jog dial to change the setting from “OFF”
to “ON”, then press the jog dial.
The display changes as follows.
525/625 SYSTEM
SELECT
ITEM-013
ON
Push SET button!!
SET button
00 : 00 : 00 : 00
AU-1 AUTO VITCON SDI
TC 525 SX-- BATT
FL display panel
(Continued)