Sony DNW-A28, Operation Manual

Page: 31 / 102

Chapter 2 Preparations
Chapter 2 Preparations
2-13
2
Press the HOLD button.
The first digit of the time data
(hours:minutes:seconds:frames) in the FL display
panel starts flashing at 1 Hz (every second).
To set all digits to 0
Press the RESET button.
3
Select the digit to set by rotating the jog dial and
press the dial.
The selected digit starts flashing at 2 Hz (every 0.5
second).
4
Set the value for the flashing digit by rotating the
jog dial.
5
Repeat steps
3
and
4
until you finish setting all
digits.
6
Press the SET button.
If the F-RUN/R-RUN switch is set to F-RUN, the
timecode starts to advance immediately.
To set timecode to the current time
1
Set the F-RUN/R-RUN switch to F-RUN and the
DF/NDF in the submenu to DF (in 525 mode only)
(see page 2-23).
2
Carry out steps 1 to 5 of “To set an initial
timecode value” to set the timecode to a time
slightly ahead of the current time.
3
Press the SET button at the instant when the
current time matches the displayed timecode.
To set user bits
You can record up to 8 hexadecimal digits of
information (date, time, event number, etc.) in the
timecode track.
Proceed as follows.
1
Press the CTL/TC/U-BIT button and select U-BIT.
2
Carry out steps 2 to 6 of “To set an initial
timecode value”.
Settings are made in hexadecimal (0, 1, 2,... 8, 9,
A, B,... E, F).
You can record ID codes in user bits. For details, see
setup menu items 603 and 604 (page 6-14).
00 : 00 : 00 : 00
AU-1 AUTO VITCON SDI
TC 525 SX-- BATT
1