99
Chaper 4 Operation Tips
Chapter 4 Operation Tips
Updating the console Version
Updating the console system
1
Confirm that you have the update files “SYSTEM
UPDATE 2.0,” on the DOS-formatted floppy disk.
2
Connect a PS/2 keyboard (optional) to the console
and turn on the power of the console.
The start-up window opens.
3
Press the ESC key on the external keyboard a few
times until the dialogue “Loading now......”
appears in white on a blue screen.
When the console system enters the update mode
of the software, the dialogue “Will you update this
system? (y/n)” appears.
4
To execute the update, press “y” on the keyboard.
If you enter this mode by mistake, press “n.”
When you press “n”, the system starts as usual.
WARNING
Never press “y” without preparing the update
floppy disks. If the DMX-R100 executes the
update operations without the correct update disk,
the console software files may be damaged and the
console may not work properly.
When you press “y”, the message “Insert the
floppy disk and press any key.” appears.
5
Insert the “SYSTEM UPDATE 2.0” disk into the
floppy disk drive on the console, and press the
space bar on the keyboard.
The specifics of the update and the “This update is
...OK? (y/n)” appear.
6
Confirm the contents on the screen, then;
• press “y” on the keyboard, to start the update.
• if the screen shows incorrect information or
parameters, press “n” to cancel the update
operation.
When you press “y”, the update programs are
decompressed, and the disk files are installed in
order, with the process showing on the screen.
When the DMX-R100 system is updated, the
message “Update for XXXX completed. Remove
your floppy disk and press any key...” appears.
7
Remove the floppy disk and press the space bar on
the keyboard.
8
When the dialogue “Stand-by....” appears, turn the
power of the console OFF of the console once.
Wait more than 10 seconds, then turn the power
ON again.
Updating the application
After updating the DMX-R100 system, perform steps
2
to
8
again, using the “APPLICATION UPDATE
2.0” disk in step
5
.
When the update of both the system and the
application are completed, the version of your DMX-
R100 will be Version 2.0.
Chapter 4 Operation T
ips
Summary of Contents for DMX-R100
