102
Chaper 4 Operation Tips
Chapter 4 Operation Tips
To the left column
Basic Operation Procedure
Basic Mixer Operation Flow from Turning On to Monitoring
The basic mixer operation is explained in the
following operation flow chart.
Example: In the following flow chart, audio from the
microphone connected to the IN A connector is routed
to CH 1 and the fader is used as a channel fader. Then
the signal is output to the PGM bus and monitored on
the control monitor. The unit is used in manual mode.
For detailed information on operations, see the page in
parentheses.
Turning on the power
The unit starts after 1 minute.
Loading the existing title or creating a new
title.
On the TITLE MANAGER window (page
82), you can create a new title or load the
existing title.
Confirming/changing the sampling
frequency and timecode
On the SYNC/TIME CODE window (page
86), confirm the sampling frequency, the
source of the synchronous signal, and the
timecode mode.
If they are not set to the desired settings,
change the settings.
Disabling automation operation
• Press the TC LINK button on the
Automation panel (page 26) to OFF.
• Press the AUTOMATION OFF button so it
is lit (i.e. off).
Routing the input signal
Confirm that AD 1 is routed to CH 1 on the
AUDIO INPUT ROUTING window (page
63).
Also, you can select AD 1 from the list of
the input sources on the SOURCE section of
the INPUT section on the INPUT/PAN/
ASSIGN window (page 45).
(Change the audio input routing as required.)
From the right column
Routing the output signal
Confirm that the PGM bus is routed to the
PGM output connector on the AUDIO
OUTPUT ROUTING window (page 65).
(Change the audio output routing as
required.)
Confirming/setting monitoring
• Select the CR MONITOR tab in the
MONITOR window (page 67) and confirm
that CUT L/CUT R buttons are set to OFF.
(Change the settings as required.)
• Press the PGM button on the SOURCE
section on the control room monitor section
on the unit (page 24) so that the button
lights up.
Setting the analog head amplifier
• Select the INPUT button on the
CHANNEL METERS section on the MISC
SETUP window (page 94).
• Release the INPUT B button on the Analog
head amplifier panel (page 13) so that the
button is not lit. The IN A connector
becomes active.
• Watching the meter of the channel (in this
example, CH 1) connected to the
corresponding head amplifier, adjust the
gain using the GAIN control on the Analog
head amplifier panel.
• In this example, set the PAD button on the
Analog head amplifier panel to OFF to
connect the microphone. (Set the PAD
button to on or off, as required.)
• Depress the + 48 V button on the Analog
head amplifier, as required.
Note
When devices other than microphones that
cannot receive power from the external unit
are connected to the IN A connector, release
this + 48 V button (not depressed). If you set
this button to ON, the external unit
connected may be damaged.
To the next page
Summary of Contents for DMX-R100
