110
Chaper 4 Operation Tips
Chapter 4 Operation Tips
Basic Operation Procedure
Manupulating
the fader
Data stored the last time
Data stored the last time
The operation performed while holding the fader
down is added to the last stored data as offset and
recalling is continued.
The following figures show the fader operation and the results
of the fader operation.
Fader operation and its results
In the figures, the fader operations are indicated using the
following lines:
: Indicates the data stored last time (previous data)
: Indicates the actual results of the fader operation
(new data).
When operating the faders in ABS mode
When operating the faders in TRIM mode
BUTT: The fader is reset to the
position stored the last time
(previous data) at the instant you
release the fader.
RAMP: The fader is reset to the
stored position at the specified
speed, when you release the
fader.
HOLD TO NEXT: After you release
the fader, the fader’s position
remains as it is up to the next
event.
HOLD TO END: After you release
the fader, the fader’s position
remains as it is up to the end.
The previous data is overwritten.
TOP TO END: After you release the
fader, the fader’s position
remains as it is up from the top to
end of the event. The previous
data is overwritten.
Manupulating
the fader
Detailed figure for the fader operation in TRIM mode
In trim mode, the offset from the NULL point (0 dB point) is added to
the previous saved data. The return mode from the drop out point to
the null point is selected in the AUTO RETURN TIME section.
Offset of the faders: when the TRIM mode is specified, all channel
faders, MTR send faders, AUX send faders move to 0 dB. The
difference between the 0 dB point and the current fader point is
adapted as an offset.
Offset for the knobs and controls other than faders: Differences
between the scale newly performed and the previous stored data
value is adapted as an offset.
Null point
DROP
IN
DROP
OUT
BUTT
HOLD TO NEXT
HOLD TO END
TOP TO END
Position stored(Left,Right components)
Position stored
(Front, Rear
components)
Position
touched
Offset
Offset of the surround pan: The difference between the latest
touched-point and the last stored point is added to the previously
stored data.
When dropped out, the pan setting returns to the point stored in
previous data according to the return mode selected.
RAMP
Manupulating
the fader
Summary of Contents for DMX-R100
