5-14
1-4.
CAMERA SYSTEM ADJUSTMENTS
Before perform the camera system adjustments, check that the
specified values of “VIDEO SYSTEM ADJUSTMENTS” are sat-
isfied.
Note:
For “CAMERA SYSTEM ADJUSTMENTS”, perform in
order of item numbers.
Data setting during camera system adjustments
Perform the following data setting before the camera system ad-
justments.
Menu setting:
1) VIDEO OUT of SET UP menu
.................................. NTSC (NTSC mode)
(This adjustment must be performed in NTSC mode, so don’t
set the menu setting to “PAL” )
Data setting method:
Order Page Address Data
Procedure
1
0
01
01
2
D
10
80
Press PAUSE button.
3
2
10
Check the bit values of bit3, bit4
and bit5 are “1”. (Note 1, 2)
4
D
11
40
Press PAUSE button.
5
D
10
81
Press PAUSE button.
5
6
C1
Check the data changes to “02”.
6
4
06
01
7
6
6C
01
8
Wait for 1 second.
9
B
75
00
Press PAUSE button.
Note 1
: For the bit values, refer to “5-2. SERVICE MODE”, “2-
3. 2. Bit value discrimination”.
Note 2:
In case of wrong data, select page: 2, address: 0A and set
data: 02.
Set the adjusting remote commander to normal rank, and
the power will be turned off and on automatically. Wait
for 0.167 second after the power on, and set the adjust-
ing remote commander to the service rank. Then, retry
from the step 1.
Note 3:
Repeat the “Data setting method”, if the power was turned
off and on during the “CAMERA SYSTEM ADJUST-
MENTS”.
After completing the camera system adjustments,
release the data setting:
Order Page Address Data
Procedure
1
4
06
00
2
6
6C
00
3
B
75
10
Press PAUSE button.
4
D
11
00
Press PAUSE button.
5
D
10
00
Press PAUSE button.
6
0
01
00
