1-14 (E)
BKMW-E3000
Fig. 1
Fig. 2
CN5
CN2
VN-13 board
Ferrite cores
VN-13 board
EPR-1 board
EPR-1 board
Shield plate
10 mm
70 mm
65 mm
IF-886 board
Harness (EPR-VN)
(Supplied accessory)
Harness (EPR-VN)
Space
IF-886 board
n
In the case of Installing Pattern [C]:
The following steps (3) and (4) are not required. (Proceed
to Step 15.)
(3) Bend the harness (EPR-VN) of the supplied
accessories as shown in the Fig. 1.
(4) Set the ferrite cores to the shield plate side, and
tuck the harness between the boards. And then
connect it to the connectors CN5 on the VN-13
board and CN2 on the IF-886 board. (Refer to
Fig. 2)
n
Be sure to open the space between the edge of the
shield plate and the harness (EPR-VN) as shown
in the figure.
15. Arrange the coaxial cables as shown in the figure, and
reattach the cable protector in the arrow direction.
16. Reattach the upper lid (rear) assembly of the VTR, and
tighten the two screws (with stopper).
Cable protector
or
(When there is
the coaxial cables
disconnected.
Summary of Contents for BKMW-E3000
Page 2: ......
Page 32: ......
Page 34: ...Printed in Japan Sony Corporation 2004 8 08 B P Company 2004 BKMW E3000 SY J E 3 857 276 01 ...
