Sony BKMW-E3000, Installation Manual

Page: 13 / 34

1-9 (E)
BKMW-E3000
5. Remove the six screws, and remove the shield plate
from the EPR-1 board.
6. Attach the IF-886 board onto the EPR-1 board.
n
In the case of Installing Pattern [C]:
Attaching the IF-886 board is not required. (Proceed to
Step 7.)
Pattern [A]
(When the DIF-109 board is not attached)
(1) Attach the hexagonal supports using the four
screws (B3
x
4) of the supplied accessories as
shown in the figure.
(2) Connect the IF-886 board to the EPR-1 board, and
fix it with the four screws (B3
x
4) of the supplied
accessories.
(3) Reattach the shield plate with the six screws.
Pattern [B]
(When the DIF-109 board is attached)
(1) Disconnect the coaxial cables and remove the four
screws, and then remove the DIF-109 board.
n
When disconnecting the coaxial cable, do not
attempt to remove by pulling the cable. Be sure to
hold the plug to remove.
Arrange the coaxial cables disconnected as shown
in the figure of step 15.
(2) Connect the IF-886 board to the EPR-1 board, and
fix it with the four screws (B3 x 4).
(3) Reattach the shield plate with the six screws.
EPR-1 board
IF-886 board
Shield plate
PWH
2.6
x 5
PWH2.6 x 5
B3 x 4
(Supplied
accessory)
B3 x 4
(Supplied accessory)
B3 x 4
(Supplied
accessory)
Hexagonal
supports
(Supplied
accessory)
Hexagonal
supports
(Supplied
accessory)
EPR-1 board
DIF-109 board
Shield plate
B3 x 4
PWH
2.6
x 5
PWH2.6 x 5
B3 x 4
Hold the plug
to remove. OK Do not attempt to
remove by
pulling the cable
NG
Coaxial cable
(Recoder only)
EPR-1 board
IF-886 board
Shield plate
PWH
2.6
x 5
PWH2.6 x 5
B3 x 4
B3 x 4