Page 37 of 87
Changing the output configuration
Each of the 4 outputs is fixed as a linear 0-‐10Vdc output.
Output values can be written using the Output Configuration tab.
To set an output to a new level, enter to required
voltage in the appropriate <
Current Values
> box
and click the <
Change
> button.
Fall-‐back Settings
Fall-‐back settings can be used to force the
analogue outputs to pre-‐determined values if the
RF-‐IOM loses communications to the parent
receiver and therefore cannot update correct
control values. Under these circumstances, it may
be desirable to ensure outputs are forced to 0V
(in most cases, an OFF state).
NB
-‐ Fall-‐back values WILL be used if the RF-‐IOM
loses communications to the parent receiver.
Careful consideration should be given to the
values used.
To set a fall-‐back output value to a new level,
enter to required voltage in the appropriate <
Fall-‐
back Values
> box and click the <
Change
> button.
Summary of Contents for RF--RXS--B
