Sonel PAT-806-IT, User Manual

Page: 62 / 76

PAT-806-IT
– USER MANUAL
60
6 Report printing
To print a measurement report set the operation with printer in general settings (par. 3.2.6). The
printer must be connected to any of the USB socket of "Host" type. To start printing, press button
. Te following will be displayed and . Printing may be activated:

after completing a single measurement, when the result is presented,

After completing the measurement in AUTO mode, when the result is presented,

while browsing the memory, if the selected cell contains data.
If the meter is set to work with the barcode reader, the meter will ask you to read the code (see
par. 5.1). This does not apply printing from a memory cell which had the barcode already saved.
Supported types of printers: Brother PT-9700PC, Brother QL-720NW, Brother QL-820NWB.
7 Data transmission
7.1 Computer connection accessories
In order to operate the meter with a PC, an USB cable is required and appropriate software. The
kit includes "Sonel Reader" software used for reading data. Increased ability to read data and create
reports are provided by "Sonel PAT" software, which can be purchased from the manufacturer or au-
thorized distributor.
The software may be used for many devices manufactured by SONEL S.A. which are equipped
with the USB interface.
Detailed information regarding software is available from the manufacturer or an authorised dis-
tributor.
7.2 Data transmission with USB port
1. Connect the cable to the USB port of the computer and the USB socket of the meter.
2. In general settings, select data transmission (section 3.2.3).
3. Start the programme.
8 Cleaning and maintenance
NOTE!
Apply solely the maintenance methods specified by the manufacturer in this manu-
al
.
The casing of the meter may be cleaned with a soft, damp cloth using all-purpose detergents. Do
not use any solvents or cleaning agents which might scratch the casing (powders, pastes, etc.).
The electronic system of the meter does not require maintenance.
9 Storage
In the case of storage of the device, the following recommendations must be observed:

Disconnect all the test leads from the meter.

Clean the meter and all its accessories thoroughly.