7
Descaling
We recommend removing any deposited scale once a month in case of hard water and every
2 months in case of medium hard or soft water.
1. When the appliance has cooled down, fill the water tank with a 1:1 mixture of water and
10% vinegar to the Max mark (1.4 litres).
2. Snap the filter holder on the machine without any filter.
3. Place a cup under the outlets (20).
4. Tap the espresso button, then wait until the program stops. Repeat this 3 times.
5. Immerse the frothing nozzle in half a glass of water.
6. Touch the steam heat-up button (11). Do not wait until the heat-up completes, but
immediately open the steam valve for approx. 1 minute. Then close it and let the appliance
stand for 15 minutes. Repeat this 3 times.
7. Tap the double espresso button (10), then wait until the program stops. Repeat this until
the water tank runs out. Repeat steps 4 to 7 with clean water until you no longer smell
vinegar.
8. Follow the steps described under PUTTING INTO USE, and then you can start using the
coffee maker again.
TROUBLESHOOTING
Error observed
Possible resolution of the error
The appliance does not brew coffee.
Check the power supply and the power switch.
Fill the water tank with water.
Use less or coarser ground coffee.
No steam is produced.
Fill the water tank with water.
Clean the frothing nozzle.
The coffee leaks over of the edge of
the filter holder.
Use coarser ground coffee.
Water appears around the appliance. Empty the drip tray.
The milk does not foam.
Wait for the appliance to heat up for steaming.
Use cold skimmed, up to 1.5% fat milk. The glass
should be of room temperature.
All three touch buttons flash quickly Heat sensor fault – contact a specialist service
None of the touch buttons illuminate
when the appliance is switched on
Thermal fuse fault – contact a specialist service
The middle touch button pulsates
This indicates standby mode, not a fault.
Touch the button.
