SOMFY SGS 201, Operating And Installation Manual

Page: 23 / 72

English
19
Copyright © 2013 Somfy SAS. All rights reserved.
Position the opening stops in contact with the cylinder knob,
then tighten the stops with a 3 mm Allen key (2 screws per
stop).
3
Turn the Allen key
twice after contact.
The remote controls supplied in the kit (Keytis NS 2 RTS) are already memorised.
Button 1 on the remote controls activates the opening of the gate.
„
Presenting the remote controls
Button 1
Commissioning
7
„
Attaching the control unit label
Attach the label (14) to the control unit.
„
Switching the installation on
Switch the installation on.
The indicator light on the control unit will flash (2 pulses) to indicate that the motors are on and awaiting setting.
If the indicator does not come on, see page 30.
„
Adjusting the opening stop
Opening end stop
The opening stops are integrated into the cylinder . They delimit the travel of the gate leaf when opening .
N.B.: Your installation must be equipped with closing stops secured to the ground to delimit the travel of the gate when closing.
Press button 1 on the remote control.
> After a few seconds, the first gate leaf opens, slowly.
if the gate leaf does not open, check that the motors are
wired as shown on page 18.
1
Press button 1 on the remote control again to stop the
gate leaf in the desired opening position.
2
During this phase, pressing button 1 on the programmed remote control only causes the gate to open and stop (1st press = open,
2nd press = stop, 3rd press = open, 4th press = stop, etc.), you can therefore set the desired opening position in several increments. it
will be possible to close the gate once the opening stops are installed.
STOP
STOP
STOP
STOP