15
/
Get heat
...
Temperature threshold...
Sun threshold...
Sensor allocation...
Delay...
The last parameters in the Get heat function menu
Timer parameters
Function
Range (Step)
Per Zone
Default
Advanced
Used
Yes/No
Yes
No
No
On Time
00:00-23:59
Yes
00:00
No
Off Time
00:00-23:59
Yes
00:00
No
Action
Up or Down
Yes
Up
Yes
Get heat
About:
The Get heat function is used to gain heat from the sun. The function acts as
a complement to the heating systems in the building. The main objective is to send
the solar protection up and use the sun’s energy to warm up the building. This is
done preferably when the building is not occupied, by using the function’s timer,
in order to avoid glaring situations when people work. Enable this function for each zone by
selecting Yes in the “use function” parameter.
Active:
This function has three criteria in order to get active. (1) When the outside temperature
is lower than the function’s outside Temperatures threshold AND (2) when the time is between
the function’s Timer span AND (3) when the function’s Sun threshold is exceeded THEN the solar
protection will be commanded up.
Enable this function for each zone by selecting Yes in the “use function” parameter.
Adapt the function:
First set the Timer’s time span (Set timer) for each zone for when this
function can be active. Then check this function’s sun Sensor allocation so that each zone
is listening to the appropriate sun sensor. If you feel that there is a possibility that the sun
could warm up even more then increase the Temperature threshold and/or decrease the Sun
threshold within this function. If you feel that the function is activated a bit too slow then
decrease the On delay and vice versa. Lastly, if you find that the function is still active even
though there haven’t been any sun for a while then decrease the Off delay and vice versa.