SOLZAIMA Alpes 10 kW, Instruction Manual

Page: 44 / 79

41
Hydraulic circuit pressure
8. Start-up
To start operating the Free Standing Pellet Fire unit, press the start/stop button for 3sec.
The display should indicate "Acendimento" (Lighting) until the completion of this phase.
The pellets will pass through the supply channel to the burning basket (combustion
chamber), where they will be ignited using a heat resistor. This process may take
between 5 and 10 minutes, depending on whether the worm screw used to push through
the pellets has been previously filled with fuel or is empty. Upon completion of the
ignition phase, the word "On" should appear on the display. The heating power can be
adjusted at any time by pressing the power selection button for approximately 1 second.
Users can choose between five preset power
levels. The selected power is indicated on the display. The initial power at each start-up
will be correspond to the power level set before the last stop.
Important note (only for the air model): Before starting up the unit, check to
determine if the deflector plate is correctly positioned.