CSE-M53G User Manual Ver. 1.0
Sollae Systems Co., Ltd.
- 57 -
8.4
Factory Reset
It is a function physically initializes all the setting. You can save a setting to
user-defined ENV region and use it as default values by the factory reset. However,
if you do not use the region, Factory Reset uses a factory default by manufacturer
as its default values.
⚫
Using Factory Reset
①
Connect pin #ISP to GND (input LOW signal).
②
Connect pin #ISP to GND (input LOW signal over 10 seconds).
③
Factory Reset will be automatically implemented to default values.
④
Disconnect the two pins from GND.
⑤
Reboot.
⚫
Setting custom default values
①
Change the mode to Serial Configuration mode
②
Save custom default values by ezManager or serial configuration commands
③
Input the command below
b
<SPACE>
3c5a
<CR>
④
After step
③
, current values in the SRAM is saved in user-defined ENV region
and the values will be always used for Factory Reset.
