Sole Diesel 68 GTC, Operator'S Manual

Page: 51 / 82

Technical specifications
Solé, S.A. C-243 b, km 2 · 08760 Martorell (Barcelona) ·Tel. +34 93 775 14 00 · www.solediesel.com · info@solediesel.com 48
Operator’s Manual Marine generator sets
GENSET
FAILURE
PROBABLE CAUSES RECOMMENDED ACTIONS SECTION
FAILURE TO
CRANK
SCO 10 PANEL
OFF mode Move to MAN mode. 7.1
Fuse (red wire) burned out
Replace the controller fuse. If the fuse blows again,
troubleshoot the controller.
5.8
ELECTRICAL SYSTEM (DC)
Battery discharged or dead Recharge or replace the battery. 5.8
Battery connections loose, corroded or
incorrect Verify that the battery connections are correct, clean and
tight.
5.8
Faulty cranking relay/stop solenoid
Check the cranking relay and the stop solenoid. If
necessary, replace.
-
Faulty starter motor Replace if it is inoperative. 5.8
FAILURE TO
START
PANEL SVT
Key switch
Check the pin connections and check that they have
voltage.
-
Electronic board Check that goes voltage electronic board to micro relay. -
ELECTRICAL SYSTEM
GENSET
Blown fuse
Replace the controller fuse. If the fuse blows again,
troubleshoot the controller.
6.8
Battery discharged or dead Recharge or replace the battery. 6.8
Battery connections loose, corroded or
incorrect Verify that the battery connections are correct, clean and
tight.
6.8
Faulty cranking relay/stop solenoid
Check the cranking relay and the stop solenoid. If
necessary, replace.
-
Faulty starter motor Replace if it is inoperative. 6.8
GENERAL Compression weak Check the compression. 6.3
LUBRICATION SYSTEM Oil viscosity too high
Check the oil viscosity (according to technical
specifications).
6.4
FUEL SYSTEM
Fuel pump faulty or clogged Check fuel pump inlet. 6.5
Fuel lines obstructed Check fuel lines. 6.5
Fuel filter clogged Replace fuel filter. 6.5
Faulty injection pump Contact with our dealer -
Air in fuel system Bleed fuel system. 6.5
Fuel injectors dirty or faulty Clean, test and/or replace the inoperative fuel injector. 6.5