Sole Diesel 68 GTC, Operator'S Manual

Page: 41 / 82

SCO 10 Panel
Solé, S.A. C-243 b, km 2 · 08760 Martorell (Barcelona) ·Tel. +34 93 775 14 00 · www.solediesel.com · info@solediesel.com 38
Operator’s Manual . Marine generator sets
Genset operator indicators
POSITION DESCRIPTION
7
Genset failure. Red LED starts flashing when genset failure occurs. After FAULT RESET
button is pressed, the light steadies (if an alarm is still active) or turns off (if no alarm is
active).
8
Genset voltage OK. Green LED is on if the generator voltage is present and within limits.
Note:
The limits for the generator voltage and frequency are given by setpoints in the Gener
Protect group.
Displays and control button
POSITION BUTTON DESCRIPTION
9
PAGE button. Use this button to switch over display pages. See Display
Screens and Pages Structure section below this table for more details.
10 UP button. Use this button to move up or increase a value.
11 DOWN button. Use this button to move down or decrease a value.
12
ENTER button. Use this button to finish editing a setpoint or moving right in
the history page.
13 Graphic B/W display, 128x64 pixels
6.3. Display Screens and Pages Structure
The displayed information is structured into "pages" and "screens". Use PAGE button to switch over the
pages.
1. The Measurement page consists of screens which display measured values like voltages,
current, oil pressure etc., computed values like genset power, statistic data and the alarm list
on the last screen.
2. The Setpoints page contains all setpoints organized in groups and also a special group for
entering password.
3. The History log page shows the history log in reverse order, so the last record is displayed first.