SolarEdge StorEdge SE5000-xxS0 series, Installation Manual

Page: 57 / 108

Communication Ports Status
D e v P r o t # #
R S 4 8 5 - 1 < S E > < S > < - - >
Z i g B e e < S E > < M P S > < - - >
l
## : The total number of slaves detected on the specific port
l
Dev : The type of device that was configured to a specific port (based on the port’s functionality), as
follows:
o
SE : SolarEdge device (default)
o
LGR : Non-SolarEdge logger
o
MLT : Multiple devices, such as meters and batteries
o
HA : Home automation devices (for load management)
l
PROT : The protocol type to which the port is set:
o
For a SolarEdge device:
RS485 protocol ZigBee protocol
S : SolarEdge slave
M : SolarEdge master
P2P : ZigBee point-to-point
MPM : ZigBee multipoint master (for the SolarEdge ZigBee
home gateway or for load management by the inverter)
MPS : ZigBee multipoint slave (for a ZigBee router module)
o
For electricity meters, refer to the application note - Connecting an Electricity Meter
to SolarEdge Devices at http://www.solaredge.com/files/pdfs/solaredge-meter-
installation-guide.pdf .
o
SS : SunSpec - for a non-SolarEdge logger (monitoring and control)
Smart Energy Management Status
This screen is displayed only when Smart Energy Management is enabled. The screen shows energy details
of the site:
S i t e L i m i t : 7 . 0 k W
S i t e P r o d : 1 0 . 0 k W
S i t e E x p o r t : 4 . 0 k W
S e l f - c o n s u m e : 6 . 0 k W
l
Site Limit : The limit that was defined for the site
l
Site Prod : The power produced by the site
l
Site Export : The power that is fed into the grid
l
Self-consume : The PV power consumed by the site
For more information, refer to the Export Limitation Application Note , available on the
SolarEdge website at http://www.solaredge.com/files/pdfs/products/feed-in_limitation_
application_note.pdf .
SolarEdge StorEdge -Single Battery/High Capacity Installation MAN-01-00283-
1.1
56
Communication Ports Status