23 of 75
5. Using a floor jack or engine hoist, raise the front crossmember up to the level of
the decks and attach it using the ½”DIA x 4½”LG hex bolts, ½” flat washers, ½”
lock washers and ½” hex nuts found in the polybag labeled “E” (Decks).
The cables running inside the crossmember must pass
between the 1/2"x4-1/2" long bolts used to fasten the crossmember to the
deck assemblies. See Figure 14.
Figure 14. Fastening Crossmember to Deck
6. Repeat the previous steps for the rear crossmember.
7. Using floor jack(s) and/or engine hoist(s), move the (4) jack stands from under
the left side deck to each corner on the crossmember.
Figure 15
Summary of Contents for Hofmann ALIGNMENT FPA18210
