Snap-on Equipment Hofmann ALIGNMENT FPA18210, Installation And Operation Manual

Page: 19 / 75

19 of 75

Assemble lower thrust washer and pulley and reinstall the pulley pin to
hold these in place.

Assemble four more thrust washers (as shown) and the top pulley with
front left cable 2-1360 wrapped around the pulley. Push pulley pin further
up to hold these in place.

Install remaining thrust washers and 1" spacer then complete assembly of
pulley pin and lock in place with hardware.

Install rear right cable 2-1363 around the lower pulley.
Figure 7. Rear Pulley Stack Assembly
Figure 8. Front Left and Rear Right Cable Installed at Rear