Smithco Sand Star Zee 45-501-A, Parts & Service, Page: 39 / 69

37
Accessories
45-510 LIGHT KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 45-627 3x3 LED Light Assembly 2
2 45-595 Rear Light Bracket 1
3 17-537 Square U-Bolt 1
4 45-611 Decal, ZTR Lights 1
5 15-727 Rocker Switch , unlit 1
6 15-782 Switch Body - unlit, On-None-Off 1
7 45-596 Front light Bracket 1
8 HB-14-20-075 Bolt 1/4 - 20 x 3/4 2
HW-14 Washer 1/4 2
HNTL-1/4-20 Lock Nut 1/4 - 20 2
NS 45-614 Wire Harness 1
INSTALLATION INSTRUCTIONS
1� Disconnect battery before installing light kit�
2. Install front light bracket (Ref 7) onto front edge of floorboard
using 1/4 x 3/4 bolts, flat washers and nylon lock nuts (Ref 8).
3� Install rear light bracket (Ref 2) on RH Roll bar tube, 30 inch-
es up from the base� Hold in place using square u-bolt (Ref
3)� Tighten�
4� Remove inside plug from right-hand control panel and dis-
card�
5� Insert switch body (Ref 6) into switch housing and push
down to lock it in place� Install rocker switch (Ref 5) onto the
switch housing�
6� Install one light (Ref 1) onto front bracket and one light onto
rear bracket� Tighten hardware�
7� Plug wire harness into rocker switch assembly and route wire
under floorboard for the front light and up the rear right roll bar
post for the rear light�
8� Plug lights into wire harness�
9� Remove the orange wire from the positive (+) post on the hour
meter and the white wire from the negative (-) post on the hour
meter�
10� Plug in the pigtail terminals from the light kit wire harness onto
the hour meter terminals� Orange to the po) and white to
the negative(-)� Then place the orange and white wires that you
removed (Step 9), orange to the po) and white tot he
negative(-) back onto the hour meter and secure��
11� Reconnect the battery� Install decal (Ref 4) behind rocker
switch and test for proper operation�
12� Secure any loose wires with tie straps provided�