![background image](http://html1.mh-extra.com/html/smc-networks/zq-a-series/zq-a-series_operation-manual_1299196022.webp)
Doc. No. ZQ-OM01301-A
- 21 -
7.2
Manifold exploded view
Procedure for increasing and decreasing the number of manifold stations
Disassembly
1.
(1) Remove the clamping rods (2 pcs.).
2.
(2) Remove end block L (Be careful not to drop the gasket).
Assembly
1.
Confirm that the ejector body gasket for manifold (7) is mounted to the gasket groove of each
single unit, and that the exhaust block gasket (8) is mounted to the outer side of the raised
part (viewed from b).
2.
Confirm that the ejector body gasket for manifold (7) is mounted to the gasket groove for
end block R (3).
3.
Confirm that the exhaust block gasket is mounted to the outer side of the raised part of
end block L (2).
4.
Put together the single units for manifold, end block R (3), and end block L (2) using the
positioning pins (a, two locations), and assemble them using the clamping rods (1).
(Recommended tightening torque: 0.54 to 0.66 Nm)
Component Parts
No.
Description
Material
Note
1
Clamping rod assembly
Steel (zinc chromate)
Refer to Replacement Part
9
.
2
End block L
POM, POM, PET, steel,
aluminum alloy, brass, SUS
Left side with the vacuum port
facing the front.
3
End block R
POM, POM, PET, steel,
aluminum alloy, brass, SUS
Right side with the vacuum
port facing the front.
4
Sound absorbing material
Non-woven fabric (PET)
Refer to Replacement Part
10
.
5
Silencer block assembly
PBT
Refer to Replacement Part
11
.
6
Ejector body gasket for manifold
NBR
Refer to Replacement Part
12
.
7
Exhaust block gasket
NBR
Refer to Replacement Part
13
.
8
Washer assembly
Steel (zinc chromate)
Refer to Replacement Part
14
.
a) part
a) part
a) part
Single unit for
manifold
b) view