Sentry 5000-32-IT Controller
Page 17 of 82
2.3.7 Assembled Stack
A completed stack is comprised of a Carrier Board and an Interface Board.
example of a stack where the Digital Output card has been installed onto the Carrier.
All Stack identifiers in Commander Logic begin with the Stack address followed by the field connection
number. When a Digital Output stack is supplied, meaning that there are two sets of relays it is important
to understand that the relay numbering begins on the Carrier Card and then continues on the Interface
Card. The (example) stack includes:
(1) Carrier Card with address switch visible
(2) Digital Output Card with replaceable relays visible/accessible
(3) Eight field connectors to support relay addresses 1 through 8
(4) Eight field connectors to support relay addresses 9 through 16
(5) Factory installed wire and ribbon cable connections for power and inter-stack and SBC
communication
A maximum of three Stacks are allowed per standard channel controller.
NOTE: Digital In the preceding description the maximum number of Interface Board Stacks is
limited by the description of the Controller cabinet space. The Controller software is
designed to allow higher numbers of stacks that may be designed into custom controllers.
1
1
1
2
5
4
3
Figure 10: Assembled Stack (Digital Output)
Summary of Contents for Sentry 5000-32-IT
