SMC Networks LECP6 Series, Operation Manual

Page: 30 / 72

- 29 -
6.3 The parallel I/O signal is detailed
- Input terminal-
No. Function Description
A1 COM+
The terminal for the 24V of the 24 VDC I/O signal power.
A2 COM-
The terminal for the 0V of the 24 VDC I/O signal power.
A3 IN0
Bit no. to specify the step data
(Specify the number by combining On / Off of the terminals.)
Example: (Bit no. to specify the step data no.3.)
IN5 IN4 IN3 IN2 IN1 IN0
OFF OFF OFF OFF ON ON
0 0 0 0 1 1
A4 IN1
A5 IN2
A6 IN3
A7 IN4
A8 IN5
A9 SETUP When SVRE (B11) is ON, the SETUP operation (return to origin operation) will be
performed. During the SETUP operation, BUSY (B7) will be turned ON and after
completion of the SETUP operation, SETON (B9) and INP (B10) will be turned ON.
A10 HOLD
I
f HOLD input is ON during operation, the speed decreases at maximum
deceleration speed of the basic parameter until the electric actuator stops. The
remaining stroke will be on hold as long as HOLD is ON and when HOLD is
turned OFF, the electric actuator restart to travel the remaining stroke.
●
When DRIVE or SETUP is ON:
Caution
As long as HOLD is ON, the DRIVE input will be disabled.
The output signals are rendered invalid whilst hold is in operation.
A11 DRIVE
When DRIVE is turned ON, the system scans the input IN0 to IN5 and starts the
operation of the
electric actuator. Then, when this terminal is turned OFF, the number
of the active step data will be output via the terminals OUT0 to OUT5.
A12 RESET
The terminal to reset the alarm and the operation. After RESET, the speed decreases
at maximum deceleration speed of the basic parameter until the
electric actuator
stops. INP and OUT0 to OUT5 will be turned OFF (however, if the
electric actuator is
stopped within the in-position range, the INP will be turned ON).
A13 SVON
The SVON signals turns the servomotor ON/OFF.
*1)
*1) When power is applied, it may take up to 10 seconds (max. 20 sec.) from SVON input to SVRE output
depending on the electric actuator position.
Binary code
Connector for CN5 of the controller
The end to be connected to a PLC, etc.
I/O cable
On hold
ON
OFF
ON
OFF
Restart
DRIVE
or
SETUP
HOLD
Speed