![background image](http://html1.mh-extra.com/html/smc-networks/jxc5h/jxc5h_operation-manual_1299615060.webp)
- 59 –
No.JXC
※
-OMY0002
Controller Setup
Software
(code)
Teaching
box name
G
rou
p
How to
deactivate
Alarm contents/ Countermeasure
The Controller
supply voltage is
outside the
specification.
(01-147)
Control
power
error
D
RESET
SVON
Input
<Contents>
The control power supply voltage within the controller is out
of a range.
<Countermeasure>
Make sure that the voltage supplied to the control power
(C24V) of the controller is appropriate.
Caution
If one power supply is commonly used for the control
power and the motor power, or the power supply is
inrush current restraining type, a power voltage drop
may be caused due to a voltage drop during the
acceleration/ deceleration.
<Contents>
The alarm may be increased by regenerative power
depending on the method of operation of the electric
actuator.
<Countermeasure>
Make sure that the operating conditions are within the
specifications.
Caution
Please refer to the manual or the catalogue of the
electric actuator for the method of operation of the
electric actuator.
The current
limit has been
exceeded
(01-148)
Over
load
D
RESET
SVON
Input
<Contents>
The output current accumulated value exceeds the specified
value.
<Countermeasure>
Check whether the movement of the electric actuator is
obstructed. Also confirm whether the electric actuator load,
speed, acceleration and deceleration are within the
specification range of the electric actuator.
Target position
(01-149)
Posn
failed
D
RESET
SVON
Input
<Contents>
Failed to reach to the set position within the set time limit.
<Countermeasure>
Eliminate any
obstructions
that interfere with the electric
actuator movement.
Also, make sure that the load, speed, acceleration and
deceleration are within the range of the
electric actuators.
A
Communication
error occurred
(01-150)
Communi
cation
failure
D
RESET
SVON
Input
<Contents>
The connection with the higher-level devices is disconnected.
<Countermeasure>
Do not interrupt the connection between the PC and
teaching box when the electric actuator is being operated by
upper-level devices.