![background image](http://html1.mh-extra.com/html/smc-networks/idfa6e-20-a/idfa6e-20-a_operation-manual_1299719014.webp)
Air Dryer
2 Transportation / Installation
IDFA6E-20
2-1
-
2-1Transportation
IDX-OM-W089
2 Transportation/Installation
Warning
Use the product in the right way. During Installation, operation, maintenance, and check,
you should be careful in keeping the safety of human body.
Caution
Transportation, installation, and maintenance including dangerous work must be done by
a personnel who has enough knowledge and experience about the product and the
sysytem.
2 - 1
Transportation
When you transport the product, you should follow the instructions below:
•
You should lift the product from the base surface with careful attention to prevent tipping over.
•
Do not lay the product sideways, or you will damage the product.
•
Do not suspend the product from the ceiling or hang from the wall.
Warning
This product is heavy.
It must be transported by more than one person, a forklift is necessary.
2 - 2
Installation
2 - 2 - 1
Location
The product should not be used or stored in the circumstances as follows. Those
circumstances will cause not only malfunction but also failures.
•
Environment where the product is exposed to
rainwater, moisture vapor, salty water, oil and
so on.
•
Locations where dust or particles are.
•
Locations where inflammable or explosive gas
are.
•
Locations where corrosive gas, solvent,
combustible gas are.
•
Locations that receive direct sunlight or where
radiant heat is generated.
•
Locations where ambient temperature is
beyond following range:
On-stream: 2 ~ 40
o
C
Storage: 0 ~ 50
o
C (when there is no drain
water inside of the piping)
•
Locations where temperature changes rapidly.
•
Locations where strong electromagnetic noise
is generated (locations where electromagnetic
field, strong magnetic field, surge is generated)
•
Circumstances where static electricity is
produced or discharged through the body of the
product.
•
Locations where strong high frequency wave is
generated.
•
Locations where danger of thunder is apparent.
•
Locations by loading on vehicles, marine
vessels, and so on.
•
Locations whose altitude is higher than 2,000
meters.
•
Circumstances where strong vibration or impact
are transmitted.
•
Circumstances where too much force and
weight are put on the body of the product that
causes it to deform.
•
Circumstances where enough spaces cannot
be taken to do maintenance (in the plant where
the product is operated).
Spaces needed for maintenance
Front
: 600 mm
Rear
: 600 mm
Top
: 600 mm
Right
: 600 mm
Left
: 600 mm
•
Locations the ventilation grille of the product
can be blocked.
•
Place where rejection style air of air
compressor or other driers (hot wind) is inhaled.
•
Place where rapid pressure fluctuation and fluid
velocity variation happen
Summary of Contents for IDFA6E-20-A
Page 47: ......