![background image](http://html1.mh-extra.com/html/smc-networks/idfa6e-20-a/idfa6e-20-a_operation-manual_1299719038.webp)
IDX-OM-W089
Air Dryer
12 Specification for Option L
IDFA6E-20 12 - 2 12-3 Installation of heavy duty auto drain
12-3
Installation of heavy duty auto drain
1. Hold the hexagon-head part Rc1/2 of the air dryer with spanner. Then install nipple, ball valve
(width across flats: 25).
Note 1) Put up the seal tape or the sealant to the nipple.
Torque: 28 to 30N
・
m
2. Hold the ball valve with the spanner. Then install a nipple and a heavy duty auto drain.
Install with “out port" down in a vertical position. Inclination from the vertical line should be less
than 5°.
3. Install one-touch fitting (width across flats: 22) to drain port (width across flats: 27) and the drain
tube.
12-4 Maintenance
1. Check drain condition periodically (more than once a day).
Then push flushing button to open exhaust valve.
2. Pilot air is exhaust from the port indicated in the figure. Do not cover this exhaust port.
Clean exhaust port so that port is not blocked by dust, etc.
3. Close the ball valve before removing the heavy duty auto drain and open the bleed valve or push
the flushing button and confirm air pressure is 0.
Order number
ADH4000-04
Type of auto drain valve
N.O( normally opened)
The highest working pressure
1.6MPa
Working pressure
0.05
~
1.6MPa
The highest drain emission
400cc/min(Pressure 0.7MPa,the case of water)
Nipple
Heavy duty auto drain
Ball valve
(Pilot exhaust port)
(Flushing button)
(Bleed valve)
Summary of Contents for IDFA6E-20-A
Page 47: ......