C
HAPTER
7
| Advanced Settings
Link Layer Discovery Protocol
– 75 –
◆
Message Transmission Interval (seconds)
— Configures the
periodic transmit interval for LLDP advertisements. (Range: 5-32768
seconds; Default: 30 seconds)
This attribute must comply with the following rule: (Transmission
Interval * Hold Time)
≤
65536, and Transmission Interval >= (4 *
Delay Interval)
◆
ReInitial Delay Time (seconds)
— Configures the delay before
attempting to re-initialize after LLDP ports are disabled or the link goes
down. (Range: 1-10 seconds; Default: 2 seconds)
When LLDP is re-initialized on a port, all information in the remote
systems LLDP MIB associated with this port is deleted.
◆
Transmission Delay Value (seconds)
— Configures a delay between
the successive transmission of advertisements initiated by a change in
local LLDP MIB variables. (Range: 1-8192 seconds; Default: 4 seconds)
The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
This attribute must comply with the rule: (4 * Delay Interval)
≤
Transmission Interval
Summary of Contents for E21011
