C
HAPTER
5
| System Settings
System Time
– 56 –
◆
Port (1024-65535)
— The UDP port number used by the RADIUS
accounting server for authentication messages. (Range: 1024-65535;
Default: 1813)
◆
Key
— A shared text string used to encrypt messages between the
access point and the RADIUS accounting server. Be sure that the same
text string is specified on the RADIUS server. Do not use blank spaces
in the string. (Maximum length: 255 characters)
◆
Interim Update Timeout (60-86400)
— The interval between
transmitting accounting updates to the RADIUS server. (Range: 60-
86400; Default: 300 seconds)
S
YSTEM
T
IME
Simple Network Time Protocol (SNTP) allows the access point to set its
internal clock based on periodic updates from a time server (SNTP or NTP).
Maintaining an accurate time on the access point enables the system log to
record meaningful dates and times for event entries. If the clock is not set,
the access point will only record the time from the factory default set at the
last bootup.
The access point acts as an SNTP client, periodically sending time
synchronization requests to specific time servers. You can configure up to
two time server IP addresses. The access point will attempt to poll each
server in the configured sequence.
Figure 22: SNTP Settings
Summary of Contents for E21011
