SXTG-5HPacD-HG
Quick Setup Guide and Warranty Information
The SXTG-5HPacD-HG comes as a complete set, and
includes a built in 802.11ac dual chain wireless device, and a
dual
polarization 16dBi, 90 degree sector antenna. It has one Gigabit Ethernet
connector which supports MDI-X
auto detection. We recommend you to set up a password to secure your device, follow these steps
First use
1.
Connect an Ethernet cable to the port behind the small plastic door
2.
The SXT accepts 24V PoE from the supplied PoE injector or 802.3af/at source
3.
Default IP address from the local network is 192.168.88.1, open this address in your web browser to start
configuration. The username is
admin
and there is
no password
Powering
The board accepts powering from the Ethernet port (Passive PoE or 802.3af/at
,
Mode B. requires
crossover cable.) 15-60V DC. Package contains a 24V adapter and a passive PoE injector.
Booting process
RouterOS is the operating system of all RouterBOARD routers. Please see detailed configuration
guide here:
http://wiki.mikrotik.com/wiki/Category:Manual
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the
Ethernet cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP
address of
192.168.88.1
with the username
admin
and no password.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the
device. More information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the
RESET button of the device when starting it until the LED light turns off (behind the small door), and SXT
will start to look for Netinstall servers.
Mounting
With the clip pointed forward, slide the mounting bracket into the rail on the bottom of the case, until the
clip clicks into place. The SXT comes bundled with a hose clamp - guide the clamp through the opening
in the bracket and around the pole where it will be mounted. Tighten the hose clamp screw when
alignment is complete. Two screw holes are provided as additional security against accidental bracket
movement.
The SXT device has a sliding door, behind which the Ethernet port and the reset jumpers are located.
This door can be also secured shut with a screw in the provided screw hole.
Buttons and Jumpers
RouterBOOT reset button (RESET, front panel) has three functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration (total 5 seconds)
See
28/10/14
