SMC Networks E21011, User Manual

Page: 200 / 264

– 200 –
26
W
IRELESS
I
NTERFACE
C
OMMANDS
The commands described in this section configure connection parameters
for the wireless interfaces.
Table 23: Wireless Interface Commands
Command Function Mode Page
interface wireless Enters wireless interface configuration mode GC 201
vap Provides access to the VAP interface
configuration mode
IC-W 201
a-mpdu Sets the Aggregate MAC Protocol Data Unit (A-
MPDU)
IC-W 201
a-msdu Sets the Aggregate MAC Service Data Unit (A-
MSDU)
IC-W 202
channel Configures the radio channel IC-W 202
transmit-power Adjusts the power of the radio signals
transmitted from the access point
IC-W 204
interface-radio-mode Forces the operating mode of the 802.11g radio IC-W 204
make-rf-setting-
effective
Implements wireless command changes made
in current CLI session
IC-W 205
preamble Sets the length of the 802.11g signal preamble IC-W 205
short-guard-interval Enables the 802.11n short guard interval IC-W 206
beacon-interval Configures the rate at which beacon signals are
transmitted from the access point
IC-W 207
dtim-period Configures the rate at which stations in sleep
mode must wake up to receive broadcast/
multicast transmissions
IC-W 207
rts-threshold Sets the packet size threshold at which an RTS
must be sent to the receiving station prior to
the sending station starting communications
IC-W 208
ssid Configures the service set identifier IC-W-
VAP
209
closed system Opens access to clients without a pre-
configured SSID
IC-W-
VAP
209
assoc- timeout-
interval
Configures the idle time interval (when no
frames are sent) after which a client is
disassociated from the VAP interface
IC-W-
VAP
210
auth- timeout-value Configures the time interval after which clients
must be re-authenticated
IC-W-
VAP
210
shutdown Disables the wireless interface IC-W-
VAP
211
show interface
wireless
Shows the status for the wireless interface Exec 211
show station Shows the wireless clients associated with the
access point
Exec 213