SMART Embedded Computing COMX-P2020 BSP, Installation And Use Manual

Page: 32 / 92

32 COMX-P2020 Module Installation and Use (6806800K97F)
Hardware Preparation and Installation
Hardware Preparation and Installation
2.4 Preparing the Installation Environment
Before you install or replace components, pay attention to the following:
 Wear an ESD-preventive wrist strap to prevent the static electricity from damaging
the device.
 Keep the area where the components reside clean and keep the components away
from heat-generating devices, such as radiator.
 Ensure that your sleeves are tightened or rolled up above the elbow. For safety
purposes, it is not recommended to wear jewelry, watch, glasses with metal frame,
or clothes with metal buttons.
 Do not exert too much force, or insert or remove the components forcibly. Avoid
damage to the components or plug-ins.
 Confirm the feasibility of the operation
There are available spare parts of the components to be installed or replaced in the
equipment warehouse. When the available spare parts are lacking, contact
SMART Embedded Computing for help in time. For details on how to get help from
SMART EC, visit http://www.smartembedded.com/ec.
Make sure that the new components are in good condition, without defects such as
oxidation, chemical corrosion, missing components, or transportation damage.
By reading this document, you are familiar with how to install and replace the
component and master the skills required by the operation.
 Check the environment
Make sure that the power supply, temperature, and humidity meet the operating
requirements for the board and its components. For details, refer to the respective
system documentation.
NOTICE
Environmental Damage
Improperly disposing of used products may harm the environment.
Always dispose of used products according to your country’s legislation and
manufacturer’s instructions.