SMART Embedded Computing COMX-P2020 BSP, Installation And Use Manual

Page: 11 / 92

COMX-P2020 Module Installation and Use (6806800K97F) 11
About this Manual
Overview of Contents
This manual is divided into the following chapters and appendices.
Safety Notes on page 15 summarizes the safety instructions in the manual.
Sicherheitshinweise on page 17 is a German translation of the Safety Notes chapter.
Chapter 1, Introduction on page 19 gives an overview of the features of the product,
standard compliances, mechanical data, ordering information, and board identification.
Chapter 2, Hardware Preparation and Installation on page 29 outlines the installation
requirements, hardware accessories, switch settings, and installation procedures.
Chapter 3, Controls, LEDs, and Connectors on page 37 describes external interfaces of the
board. This includes connectors and LEDs.
Chapter 4, Functional Description on page 69 includes a block diagram and functional
description of major components of the product.
Chapter 6, Firmware Upgrade on page 81 describes the procedures in upgrading the
firmware.
Chapter 7, Operating System and Driver Support on page 87 lists the drivers and operating
systems supported by the product.
Appendix A, Related Documentation on page 89 provides a listing of related product
documentation, manufacturer’s documents, and industry standard specifications.
Abbreviations
This document uses the following abbreviations:
Abbreviation Definition
COM Express Computer-on-Module Express
COP Common On-chip Processor
CRC Cyclic Redundancy Check
DDR Double Data Rate
DMA Direct Memory Access
DRAM Dynamic Random Access Memory
DUART Dual Universal Asynchronous Receiver/Transmitter
ECC Error Correction Code