17
5251
5
2022
-
SPS-B
MG_0217
2
1
3
IMPORTANT
The surface MUST BE flat
within tolerances and parallel
with the outer hulls angle in the
centre of the actuator.
Ø18 mm
Hull thickened area to
meet tolerances
Sealant area
55 mm
185 mm
222.5
mm
150
mm
194.5 mm
Mechanical Installation
1. Mark the positions of the holes for the securing bolts.
(NB: Use the external securing plate as a template.)
2. Cut & drill the holes using appropriate cutting and drilling equipment.
3. Apply a moderate coating of watertight sealant to the mating surface.
(NB: Sealant must be compatible with hull material. A naval architect/
Boat builder must confi rm this. )
MC_0216
!
Please refer to the graphic for special considerations relating to your model
!
MG_0219
1
2
3
4
IMPORTANT
Use appropriate lifting equipment (for example a sling)
to lift the Stabilizer Actuator.
DO NOT lift or attach lifting equipment to the actuating
cylinders or their rams.
Sealant in centre
hole gap.
Countersunk all holes
Temporary securing
bolts
Mechanical Installation
MOUNTING OF THE STABILIZER ACTUATOR ASSEMBLY
1. Carefully lower the Stabilizer Actuator Assembly into the hulls actuator hole in the correct orientation to the sealant mounting surface.
2. Use two of the securing bolts to temporally lock the Actuator Assembly into position.
3. Countersunk all holes to allow space for bolt heads and sealant without damaging the hull.
4. Apply sealant in the gap of the centre hole in the hull to the Actuator shaft core.
MC_0216
!
Please refer to the graphic for special considerations relating to your model
!