SkyWave IDP-680, Hardware Manual

Page: 45 / 64

IDP 600 Terminal Series - Hardware Guide
© SkyWave Proprietary 35 T200, Version 02
5
Cable Assembly Instructions
This section provides the information necessary for the Solution Provider to assemble
IDP power/interface cables for the end-user. The solder cup cable connector kit ships
with the terminal.
Figure 30 Basic Connector Parts for Soldering Configuration
5.1 Required Tools and Materials
The following tools and materials are required to build the cable using this method:

A cable
7
appropriate for the terminal’s environment

A knife

A wire stripper

Solder

A fine-tip soldering iron

A flexible high temperature silicone sealant for outdoor exposure
5.2 Cable Assembly Steps
1. Use a knife to cut and remove the outer jacket of the cable, 20 mm from the end
(Figure 31) and remove any foil shielding.
CAUTION Be careful not to nick the wire insulation.
2. Use a wire stripper to remove 5 mm of insulation from the wires (Figure 31).
Figure 31 Recommended Stripping Length
7
For cables exposed to extreme temperatures and sun, select a cable with a thermal rating of
-40°C to +85°C and a UV resistant jacket.
Connector
Body
Coupling Ring
Back Shell
Sealing Nut