TRAMPOLINE ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
•
Need phillips screw driver and 2 adjustable wrenches (putting the trampoline together). A rubber mallet may make assembly
easier, however.
•
Assembly requires two persons.
•
Wear gloves to protect your hands from pinch points during assembly.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface before using it.
2. Adequate overhead clearance is essential. A minimum of 24 feet from ground level is best. Provide clearance for wires, tree
limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline away from walls, struc-
tures, fences, and other play areas. Always have a clear space on all sides of the trampoline.
3. Use the trampoline in a well-lighted area. Electric lights may be required for shady areas.
4. Secure the trampoline against unauthorized and unsupervised use.
5. Remove any objects from beneath the trampoline.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
15
2
Insert the short frame tube #3 into tube #4.
Continue this with tubes #5 and #6. Note:
the end marked “A”should be attached tog-
ether and “B” is together as shown.And ma-
ke sure the holes side of the tubes are top.
Becareful your fingers.
3
4
5
6
3
4
5
6
A
B
A
B
hole
1
Begin by putting the frame tubes on the ground as shown.
Make sure that all the hook holes face above.
And put the “A” or “B” on the tube#3/4/5/6 together each as shown.
3
Lay the two “T” joints(7) on the ground as shown.
7
3
6
3
Hook Holes
Hook Holes
6
