21
ENCLOSURE ASSEMBLY
1
Lay both the upper (15) and lower enclosure poles (16) on the ground, then
attach the tubes with an M4.8x16 screw (27) and Lock Washer (31).
Attach the remaining top and bottom enclosure poles together in the
samew manner. The foam sleeves shouold slide freely onto the poles.
2
Expand the enclosure net (14) on the ground and
lay flat with straps facing outward.
3
Attach the enlosure pole and Cap (27) to the net with a cap
finger bolt (28) by aligning the holes in the enclosure pole
with the holes in the pole cap and the grommet in the mesh.
4
Repeat step 3 and attach the other 5 enclosure poles to the
net as shown. After attaching the first 3 poles, it is helpful to turn
the mesh over, to expose the other set of 3 grommets.
lower pole(15)
upper pole(16)
14
27
two holes
5
Gather mesh and the attached poles togher.
6
Carry the mesh with poles and lay on trampoline
bed with upper poles toward the centre of the
trampoline. Lay the poles around the trampoline
frame, having each bracket corresponding with each
pole.
Note:The enclosure door is located per the
left drawing instruction.
Enclosure Door
Enclosure Door Location Instruction
Enclosure Door
C
Holes
B
27
8
Strap ring
Strap
7
27
Hole
28
Hole
A
27
Hexagon hole