17
9
11
Continue step10
,
one hand lift the frame tube, have another hand drag the support tube(13) , see inset A,
until it can touch the socket as shown in inset B. Insert the support tube(13) into the socket tube, locked by pin.
10
Lift the frame assembly up as shown,and
adjust the two leg assemblies to be apart as the
arrow shown.
Turn over the frame assembly with one leg assembly. Repeat step8
to attach another leg assembly to the
pivot points on the
frame.
Note:
Have one person lift the leg assembly up and down as the
arrow shown until the holes are lined up.
13
Inset A
Inset B
13
Socket
5
Pin
Holes
8
Attach one leg assembly to the frame assembly at the pivot points marked with “A” and “B” with two p
rotective plates (22)
,
two M8x40mm bolts (23) and two M8 Locknuts (26) each for side.
Make sure that the straight edges of the protective plates against
the bracket as shown. Make sure the indicated slide slot in the Protective Plate(22) is away from the leg assembly, and the holes
on both leg and frame bracket are lined up so that the bolts can go through easily. And be note that the side with “A” of the frame
is attached to the leg side with “A”, same to “B” side. Be careful not to pinch your fingers! Note: Have one person lift the leg
assembly up and down as the arrow shown until the holes are lined up. Make sure the Leg Assembly can rotate smoothly.
Leg Assembly
Slide Slot
22
23
Straight
Edge
Straight Edge
A
R
L
A
B
B
A
