16
6
Lay the leg assembly tubes shown above on the ground, screw both right leg 2(9-1) and left leg 2(8-1) tubes to the middle
tube(10) with two M4.8X16mm screws (27) as shown in Pic C. Attach the brace tube (13) to the “U”- joint in the middle
of tube (10) with an M8X45 (24) and an M8 locknut (26) as shown in Pic D.
Make sure that the chamfer side of the
brace tube is against the inside of the “U” -joint - this will allow each leg to properly fold down. The open side of
the plastic clip on middle brace faces down.
Left Leg 2
Right Leg 2
L-2
R-2
L-1
R-1
Middle Tube
Brace Tube
C
D
Chamfer
side
“U”- joint
Brace tube
7
Repeat step 6 to assemble the other right and left legs 2 assembly. Note: when the right legs(9) of the two leg assemblies
are stacked on top of one another, the open side of the “U” joints on the middle tubes must face in opposite
directions (as shown in the inset pic above).
Left Legs
Right Legs
Open Sides face in
opposite directions
4
Attach one “T” joint
（
7
）
to the frame tubes (3/6) with two M8x55mm Shoulder Bolts
(
21
)
and two M8 Locknuts
（
26
）
as shown.
Make sure the center of the
corresponding holes be aline refer step5. Make sure the indicated Pin is open.
Repeat this step to attach another “T” joint(7).
5
During assembling the “T” joints(7) in
step 4, one person holds one half frame as
shown, and rotate as the direction of arrow
help the holes align. After finishing assembly
of the “T” joints(7), over -lap the two halves
frames together.
6
3
6
21
21
21
26
Pin Holes
INSIDE of Assembly
OUTSIDE of Assembly
Pin
7
Bolt Hole
