Edition 18.12.19 |
Product design and technical data may be subject to change
A
70
B
35
C
Parts
42
100
100
53
unios.com
Page
1/4
Zenith
Install Person/s
1x
Sizing Variations
ZENI0002
Product Code
Canister
ZENI0002
All measurements are in millimetres.
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
CAUTION
– This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
Material
Aluminium
IP Rating
65
Class III
24V DC
INGROUND UPLIGHT
2W
ZENI0002
Base
Codes
Power
2 Watts
1x Allen Key
1x Canister
Luminaire
Canister
A
C
B
A
C
B
FOR WARRANTY INFORMATION VISIT
UNIOS.COM/WARRANTY
Please read these installation instructions carefully before installing this luminaire. The luminaire is
designed for installation in accordance with relevant Australian Standards (AS/NSZ 3000).
Installation of this luminaire must comply with local and national regulations. If luminaire is not
installed according to the instructions, the warranty for the luminaire may be void.
ENQUIRIES
+61 8 9248 1888
Edition 18.12.19 |
Product design and technical data may be subject to change
unios.com
Page
4/4
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on the
luminaire will cause corrosion of the surface of the luminaire
and will void the warranty.
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment)
Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1
2
