Skyjack SJ519 TH, Service Manual

Page: 85 / 108

85
SJ519 TH 216942AC
250 Hour or Quarterly Routine Maintenance Section 4 – Procedures
6. Remove oil drain plug and allow all engine oil to
drain into container. See figure below.
Engine Oil
Filter
Oil Drain
Plug
Figure 19 Engine Oil Draining
7. Install oil drain plug with a new seal ring and
tighten firmly.
8. Remove oil filter and catch any escaping oil.
9. Clean inside the filter head.
10. Apply a thin layer of engine oil to the new oil filter
gasket.
11. Screw on new filter by hand until the gasket is
touching then tighten to a torque of 7-9 ft.-lb. (10-
12 Nm).
12. Clean up any oil that may have spilled during this
procedure.
13. Refill engine with new oil through the fill area.
Refer to
2.4 Recommended Fluids/Lubrications .
Engine Oil
Fill Cap
Oil
Dipstick
Figure 20 Engine Oil Fill Cap
14. Start engine and allow it to run for 30 seconds
then stop the engine.
15. Check for oil leakage.
16. Check engine oil level on dipstick and add oil if
needed.
17. Close the engine compartment cover then latch to
secure in place.
NOTE
Refer to your local/national regulations on how to
dispose of used filter and oil.