Skyjack SJ519 TH, Service Manual, Page: 89 / 108

89
SJ519 TH 216942AC
1000 Hour or Annual Routine Maintenance Section 4 – Procedures
11. Lower the boom until the forks are resting on the
ground and an upward force is being applied to
the boom sections.
12. Shut off the engine and remove key.
13. Measure the slide shoe clearance at the top of
each boom section. Clearance should range not
exceed 0.025 in. (0.63 mm).
14. Start the machine and raise the boom high
enough to lift the forks off the ground.
15. Shut off the engine.
16. Measure the side slide pads clearance using the
same procedure as outlined in step 8 for the side
slide pads at the front of the boom.
17. If clearances are within 0.08 in. (2 mm), install the
rear boom cover.
NOTE
If any of the clearances are greater than 0.08 in.
(2 mm), shim adjustment or replacement of the
slide pads may be required.
5.5 1000 Hour or Annual
Routine Maintenance
5.5-1 Change Hydraulic Oil Filter
1. Ensure telehandler is on a firm level surface,
apply the park brake and shut down the engine.
2. Unlatch engine compartment cover and lift up to
gain access to Hydraulic Oil Filter.
3. Place suitable container under filter to catch any
spilled oil.
4. Unscrew and discard old filter. Be sure all traces
of the old filter gasket are removed from the filter
head.
Figure 28 Hydraulic Oil Filter Location
NOTE
Refer to your local/national regulations on how to
dispose of used hydraulic oil filter.