Skyjack SJ519 TH, Service Manual

Page: 95 / 108

95
SJ519 TH 216942AC
Non-Routine Maintenance Section 4 – Procedures
For installation of the side wear pads:
NOTE
Use a pry bar to hold the wear pads and shims in
position.
7. Clean installation area to remove any residual
grease. Ensure threads are free of grease, dirt.
8. Install the side wear pad assemblies.
9. Apply blue loctite and tighten the screws to 37
ft-lb. Ensure there is approximately an equal
number of shims under each wear pad.
10. Lubricate all wear pads with MPG-EP2 grease.
11. Extend and retract the boom and check for
smooth operation.
12. Install the rear cover.
5.6-2 Display Fault Codes
The display reconizes error messages that are sent
from the engine via the data link. If a new error
message is received, the display will begin to beep,
and a flashing pop-up window will open with the latest
error messages and details.
2
3 4
Button 5
Button 1
Figure 34 Engine Data Display Module
If a new error message is received, the display will
beep and a flashing popup window will open with the
latest error messages and details.
STOP
Figure 35 Error Message Popup
The error list is displayed by pressing any button.
The errors already viewed appear in black text on a
grey background. New messags that have not been
read yet appear as emphasized grey text on a black
background. The alarm last received is automatically
displayed the first time the error list is called up.
If the list is longer than the screen section, you can
browse through the list using buttons 1 and 2.
ACTIVE FAULT
SHUT OFF REQUEST
SIGNAL LOSS
PRESS ANY KEY
Figure 36
Error Message
The display cannot be quit until all alarms have been
acknowledged by pressing button 3. The error list
display can be activated at any time by pressing
button 4.
The following pages contain information regarding
the display Fault Codes; including the SPN code,
FMI code, description of the fault code, as well as the
recommended action to take.