BODY/FRAME
Vehicle Cleaning and
Protection
Remove any dirt or rust.
To clean the entire vehicle, use only
flannel cloths or equivalent.
CAUTION:
It is necessary to use
flannel cloths or equivalent on
windshield and hood to avoid dam-
aging further surfaces to clean.
To remove grease, oil and grime, use
Heavy duty cleaner (P/N 293 110 001)
(spray can 400 g) and (P/N 293 110
002) (4 L).
CAUTION:
Do not use Heavy duty
cleaner on decals or vinyl.
To remove stubborn dirt from all plas-
tic and vinyl surfaces, use Vinyl & Plas-
tic Cleaner ((P/N 413 711 200) (6 x
1 L)).
To remove scratches on windshield
or hood use the Scratch Remover Kit
(P/N 861 774 800).
CAUTION:
Never clean plastic parts
or hood with strong detergent, de-
greasing agent, paint thinner, ace-
tone, products containing chlorine,
etc.
Clean sheaves of both pulleys using
Pulley flange cleaner (P/N
413 711
809).
Inspect the hood and repair any dam-
age.
Touch up all metal spots where paint
has been scratched off. Spray all met-
al parts including shock chromed rods
with XP-S Lube (P/N 293 600 016).
Wax painted portion of the vehicle for
better protection.
NOTE:
Apply wax on glossy finish on-
ly. Protect the vehicle with a cover to
prevent dust accumulation during stor-
age.
CAUTION:
The snowmobile has
to be stored in a cool and dry
place and covered with an opaque
tarpaulin.
This will prevent sun
rays and grime from affecting plas-
tic components and vehicle finish.
Lift rear of vehicle until track is clear
of the ground. Install on a wide-base
snowmobile mechanical stand with a
rear deflector panel.
WARNING
Do not attempt to lift the vehicle
by hand alone. Use appropriate
lifting device or have assistance
to share lifting stress in order to
avoid risk of strain injuries.
NOTE:
Do not release track tension.
Bulb Replacement
Always check light operation after bulb
replacement.
Headlamp
CAUTION:
Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
By using a small screwdriver, release
multifunction gauge locking tabs.
mmo2007-009-061_a
1. Locking tab
96
______________________
Summary of Contents for MX Z TNT 600 HO E-TEC
