Ski-Doo MX Z TNT 600 HO E-TEC, Operator'S Manual, Page: 48 / 120


WARNING
Make sure parking brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss of
braking capacity and/or fire.
To Engage Mechanism
Squeeze brake lever and maintain
while pulling locking lever with a fin-
ger.
When brake lever is held at
halfway the parking brake should be
fully applied.
CAUTION: Parking brake position
can vary depending on brake pads
wear.
Ensure when the parking
brake is applied that the vehicle
stays securely in place.
NOTE: Locking lever can be adjusted
in two different positions.
mmo2007-009-037_a
TYPICAL — ENGAGE MECHANISM
Step 1: Squeeze and maintain brake lever
Step 2: Adjust locking lever
1. Position 1
2. Position 2
3. OFF
To Release Mechanism
Squeeze brake lever. Locking lever
will automatically return to its origi-
nal position. Always release parking
brake before riding.
mmo2007-009-037_b
TYPICAL — RELEASE MECHANISM
Step 1: Squeeze brake lever
9) Electronic Reverse
(RER) Button
When pressed, it allows selection
the electronic reverse, refer to
SHIFT-
ING IN REVERSE in OPERATING IN-
STRUCTIONS section for procedure.
mmo2007-003-003_e
1. Electronic Reverse (RER) Button
10) Headlamp Dimmer
Button
When pressed, it allows selection of
headlamp HI or LOW beam.
A gauge pilot lamp will indicate head-
lamp HI beam position.
Lights are automatically ON whenever
the engine is running.
_____________________
45