Ski-Doo MX Z TNT 600 HO E-TEC, Operator'S Manual, Page: 94 / 120

To Adjust Track Alignment:

WARNING
Remove the tether cord cap (DESS
key) before performing any main-
tenance or adjustment, unless oth-
erwise specified. Vehicle must be
parked in a safe place, away from
the trail.
– Remove the tether cord cap (DESS
key).
– Loosen rear idler wheel retaining
bolts.
– Tighten the adjustment bolt on side
where the slider shoe is the farthest
from the track insert guides.
A01F0BA
1 2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
Tighten retaining bolts.

WARNING
Properly tighten wheel retaining
bolts, otherwise wheel may come
off and cause track to “lock”.
mmo2008-003-047_b
TYPICAL
1. Retighten to 48 N•m (35 lbf•ft)
Restart engine and rotate track slowly
to recheck alignment.
Reposition snowmobile on ground.
Install rear wheel caps if so equipped.
_____________________
91